Celebrating 70 Years of Service (803) 888-4115
Thermostat replacement is one of the smallest HVAC jobs and one of the most commonly botched, because a thermostat has to match the system behind it. Kaminer Heating And Cooling installs and configures thermostats across Columbia and the Midlands, including on heat pumps where auxiliary heat staging has to be set up correctly.
A thermostat that does not properly control a heat pump will run auxiliary heat far more than necessary, and the homeowner finds out when the power bill arrives. Standard thermostats often do not handle heat pump staging correctly. If you have a heat pump, the thermostat matters more than it does on a straightforward furnace and AC setup.
A smart thermostat saves money if you actually use the scheduling and you are often out of the house. If the house is occupied all day and the temperature stays where you like it, the savings are modest and the main benefit is convenience and remote control. Both are legitimate reasons to buy one — we just would not sell it to you on savings that will not materialise.
Many smart thermostats need a C wire to power themselves, and plenty of older Columbia homes do not have one run to the thermostat location. That is solvable, but it is the reason a straightforward-looking swap sometimes turns into a wiring job. We check before quoting.
A thermostat on an exterior wall, in direct sun, above a lamp, or near a supply vent reads a temperature that is not representative of the house. The system then heats or cools to satisfy a sensor that is lying to it, and every room suffers for it. Relocating a badly placed thermostat frequently resolves comfort complaints that look like equipment problems and have been attributed to the system for years.
Worth having: scheduling you will actually use, remote access if you travel, filter reminders, and on a heat pump, proper auxiliary heat control. Worth skipping: most of the rest. A thermostat with a dozen sensors and a learning algorithm will not outperform a basic programmable unit in a house that is occupied all day at a steady temperature.
Installing a thermostat takes twenty minutes. Configuring it correctly for the system behind it — stages, heat pump changeover, auxiliary lockout, cycle rate — is the part that determines whether it costs or saves money. That is where a swap goes wrong, and it is invisible until the first unusual bill.
On a simple furnace and AC system with a C wire present, often yes. On a heat pump, a multi-stage system, or where no C wire exists, it is worth having it done properly.
On a heat pump that means the backup heating element is running. In genuinely cold weather that is normal. In mild weather it points to a configuration or system fault and it is costing you money.
It can, mainly through scheduling when the house is empty. If the house is occupied all day, expect convenience rather than large savings.
A common wire that provides continuous power to the thermostat. Most smart thermostats need one, and many older installations do not have it.
Not always obvious. Before replacing it, check the breaker and the furnace switch. If those are fine, we can diagnose which it is rather than you replacing a thermostat that was never the problem.
Call (803) 888-4115 or get in touch. Kaminer Heating And Cooling, 110 Kaminer Way Pkwy, Columbia, SC 29210. Serving Columbia, Irmo, Blythewood, Chapin, Cayce, Lexington, Seven Oaks and West Columbia.